Rear panel removal
 

To get wiring to the front of the truck the best way is under the sill plates. To make things easier I recommend removing the cargo area rear side panels. They are easy to remove. This is also required to gain access to the Bose Amp and wiring or get wiring from the cubby hole to the sides.

The upper panel must be removed first. This is done by removing the phillips screw located in figure 1, unscrewing the cargo net knob shown in figure 2 and removing the rear seat shoulder harness in figure 3 which will require a torx bit.

Remove the trim piece shown in figure 5 and the lower panel just snaps loose.

 

Return to main audio page

Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
 

tbssowners